Torque Settings

When fixing screws to Ubisense devices, we strongly recommend that you use a manual torque driver, rather than an electrical torque driver, for the following reasons:

  • The screws and screw heads are of a small size.

  • The enclosure might get damaged if you use an electrical torque driver.

The torque settings you must use are listed in the following table.

Product Target Setting Acceptable Range Bit Required

UWB Sensor (body)

 0.9 Nm 0.8 Nm to 1.1 Nm Torx T10 (long reach)

UWB Sensor IP Cover (with gasket)

 0.9 Nm 0.7 Nm to 1.0 Nm Torx T10 (long reach)

UWB Sensor IP Cover (without gasket)

 1.1 Nm 1.0 Nm to 1.2 Nm Torx 10 (long reach)
  • Industrial Tag
  • Multi-mode Tag
0.8 Nm 0.7 Nm to 1.0 Nm Torx 10 (long reach)
  • Integrated Tool Tag
  • Head and Battery Unit Tool Tag
0.5 Nm 0.45 Nm to 0.55 Nm Torx T8
  • Mini Tag

0.3 Nm

0.25 Nm to 0.35 Nm

Wera 05059910001